Cutters & Shredders in College Station, TX

For a few acres of pasture edges, a single-deck rotary cutter usually does the job. It pulls behind your tractor and handles grass, light brush and fence lines. A flex-wing cutter adds wing sections that hinge up and down. It covers more ground per pass and follows uneven ground without scalping it. Wide open ground favors the flex-wing. Tight gates and corners favor one deck. Bad Boy builds both. Browse our implements on j5tractors.com to compare them, or come by the store and talk through the ground you're working.

Yes, a rotary cutter is built for more than grass and weeds. It's heavy equipment made for brush, small saplings and overgrown fence lines, not a finish mower. On ground that's gone a season or two without being cut, a rotary cutter can take back pasture a finish mower never could. Go slow in the thick stuff. Bad Boy builds rotary cutters and a flex-wing for that heavier work, and our Bryan store carries them. The right fit depends on how thick the brush is and how much ground you're covering.

That bolt is doing its job. It's a shear bolt, and it's built to snap when the blades hit something solid, so the PTO shaft and gearbox don't take the shock. College Station acreage hides stumps, rocks and old fence posts in tall grass. You replace the bolt and keep going. Some cutters use a slip clutch instead, which slips under a hard strike and then grips again. Either way, it's the part that's meant to give first. Snapping them often? Raise the cut or slow down. Bad Boy rotary cutters are worth a look at our Bryan store.

Start by looking at what's actually growing there, brush, saplings or just tall grass, since that decides which cutter does the job. Keep well back from ditch banks and drop-offs rather than running the cutter right up to the edge. Watch for fence posts, loose wire and old stumps hiding in tall growth. A rotary cutter will hit what it can't see coming. A flex-wing cutter covers more open pasture in a pass. A standard rotary cutter works tighter spots like fence lines and corners. Bryan is where we carry both styles from Bad Boy.

No. A rotary cutter or flex-wing is its own purchase, and it fits most brands of tractor. If you already have a tractor, the cutter behind it is all you need. That's common. Come by the Bryan store to see what's on the lot, since it changes week to week. Whatever you pick still has to fit through your gates and on your trailer. Measure those first. Check the cutter's PTO horsepower rating against your tractor's too. Financing a cutter starts with our easy online credit application.