Implement Parts in Hearne, TX

Send us a parts request online, or call the store and ask. The parts counter handles ordering implement parts that aren't on the shelf. Have the implement's model and serial number ready when you reach out. It helps match the right part the first time. Look for a tag or plate on the frame, often near the hitch. Robertson County ground is rough on pins, bushings and cutting edges, so tell the counter what broke and how. You can send a request from your phone, then call if you'd rather talk it through.

Cutting edges and scarifier teeth wear first on a box blade. They drag through dirt every pass, so they round off and get shorter. Most edges bolt on, so you replace the edge instead of the whole blade. That's the point. The pins at the hitch and top link wear too, along with their holes. A land grader's blade edge wears the same way. Hydraulic hoses and fittings matter on implements that run off the tractor's hydraulics, like a front grapple. The counter handles all of these. Ask what's there today, since the shelf changes.

Shear bolts, U-joints and gearbox seals are the driveline parts you'll order most often for a rotary cutter or tiller. Robertson County fields have stumps, roots and uneven ground that load up a driveline. A shear bolt is built to break before something bigger does. That's its job. Some cutters use a slip clutch instead, which slips under a hard strike. U-joints and gearbox seals wear slower. If you're already ordering shear bolts, it's worth asking about those too. A seal that's weeping oil is the one to catch early.

Order ahead. Spring is when cutters go back to work, and a broken blade or sheared bolt mid-job ends your day. Spare shear bolts come first. They're made to break, and the cutter stops until one's replaced. A set of blades with new blade bolts comes next. Blades nick and dull on rocks and stumps, and they're swapped as a set to stay balanced. Grease for the driveline and the gearbox oil your manual calls for are worth having in the barn too. Anything the counter doesn't have on a given day can still be ordered.

It isn't required, but bringing the worn part can help the counter match it. That's especially true for blades, bushings and pins, where size and hole spacing matter. A photo works too. Snap the part, the spot it came off and the tag on the implement frame. That can save a trip if the part has to be ordered. A tape measure helps as well: blade length, bolt size and pin diameter narrow it down. Either way, give us a call if you want to talk through what's wrong before you order.