Cutters & Shredders in Huntsville, TX

A rotary cutter is the usual pick for brush, but a flail has its place. A rotary cutter's spinning blades knock down brush, saplings and tall grass in one pass. It's the tool to reach for on pasture that's gotten away from you. A flail uses a row of small knives on a spinning drum. It cuts finer and leaves a more even mulch. It also tends to throw less debris, which matters near a house, a road or a fence. Lighter growth close to the house suits a flail. Thick brush on a timber edge calls for a rotary cutter. Both run off your tractor's PTO.

Yes. A rotary cutter is built for more than grass. The heavier models cut through saplings, brush and briars that a mower blade can't touch. Lighter rotary cutters work well for keeping open pasture mowed back before grass and weeds get ahead of you. Check the cutter's rated cutting capacity before you take on saplings. Walker County ground that's gone a season or two without cutting often needs the heavier pass first, then lighter upkeep after that. Browse our implements on j5tractors.com, or come by the store with questions about which cutter suits the brush you're clearing.

A flex-wing cutter has wings on each side that flex up and down over bumps and ruts. So it holds a more even cut than a fixed-deck rotary cutter. It also covers more ground per pass, which helps on larger acreage. A standard rotary cutter is lighter. It's easier to maneuver around fence lines, trees and tight corners. If your pasture is mostly flat and open, a standard cutter gets the job done. If you're covering ground with ruts, stumps and uneven footing, the flex-wing's extra reach pays off. Think about your tightest gate, too. A wide flex-wing has to fit through it.

Pasture in Walker County usually needs more than one cutting a year to keep brush and saplings from taking hold. Pine and hardwood country like this grows back fast, especially after a wet spring. Catching regrowth early, while it's still small, is easier on the equipment and the ground than waiting until it's thick and woody. You might run a heavier cut once brush gets ahead of you, then follow up through the growing season as regrowth comes back. How often depends on your ground and how long it's been since the last pass. Come by our Conroe store and see what's there.

Rough ground is normal on cleared pasture. Ruts, stumps and uneven footing show up on pasture edges and land that's been cleared recently. A rotary cutter or shredder is built to run over that kind of ground, but it's smart to watch what's ahead. Slow down over rough spots. Watch for stumps as you go, and keep the deck off any you spot. Larger stumps are still worth knocking down or pulling before you mow, since a big one can stop the blades or damage the deck. Keep well back from ditch banks and drop-offs while you're at it. Set the deck level so the blades don't scalp high spots.