Cutters & Shredders in Navasota, TX

Higher than you think, most times. Leaving three or four inches of stubble protects the grass crown and keeps the blades out of the dirt. Cut too low and you'll scalp the high spots, dull the blades on soil and rock, and leave the pasture slower to come back. Set the tail wheel first, then level the deck front to back with the top link. A slight nose-down tilt helps the blades pull material in cleanly. Grimes County pasture is uneven enough that a deck set tight will find the high spots for you. Raise it a notch on rough ground.

A heavier cutter is at its best once you're past light pasture mowing and into real brush and small trees. Standard rotary cutters handle grass, weeds and light overgrowth without a fight. That part is easy. Once saplings or thorny brush show up, a heavier-built cutter with thicker blades and a stronger deck holds up better under that load. Grimes County ground can run either way, with open coastal pasture in one field and brushy fence lines in the next. Think about the toughest stretch you'll cut, not just the easy acres. The classic mistake is a tractor bought to maintain a place, pressed into clearing one. It can be done. It's slow, and it's hard on the machine. Browse our implements on j5tractors.com to compare models, or stop by our Navasota store and talk through what your ground needs.

Cutting width comes down to how tight your ground is and how much you need to cover in a pass. A narrower cutter turns around trees, fence corners and wooded edges without a fight. That's the deciding factor. A wider deck covers open pasture faster but needs more room to turn around. Brazos Valley land near Navasota mixes both, with open hay ground in one field and tighter timber edges toward the river bottom in the next. Match the width to your tightest gate or narrowest tree line, not your biggest field. Deck size follows the tractor too. Size the cutter to the tractor you run, and check its horsepower and hitch before you pick a width.

Yes. A shredder knocks down heavy grass, weed stalks and stubble left after a cutting. It chops material fine instead of just laying it over, so it breaks down faster on the ground. That matters. Regrowth comes on quick after second and third cuttings in summer, and you'll want the field clean ahead of it. Fence lines get the same treatment. Keep well back from ditch banks and drop-offs while you work. Your cutter's operator's manual is the one to go by near ditches, embankments and holes. Come by our Navasota store and look over a cutter built for that cleanup work.

Our Navasota store carries Mahindra implements, including rotary cutters and shredders built for pasture and brush work, alongside IronCraft and Modern Ag Products implement lines. Come compare them. Grimes County acreage runs the gamut, from open coastal bermuda to brushy ground near the Brazos River bottomland, so having more than one option on the lot helps. Which one fits depends on what you're clearing, how heavy the growth is, and how you want the ground to look afterward.